• Weitreichende Unterstützung
    Weitreichende Unterstützung
Bookmarks:
FacebookLinkedInXingYouTube

Neues Linux BSP Rev.0106 für TQMa28 / TQMa35

Donnerstag, 16. Januar 2014

Neuer U-Boot und Kernel, diverse Verbesserungen

TQ-ARM-BSP Rev.0106:

- TQMa28/28L-AB/28L-AA

    * Linux version 3.10 (device tree) (3.10-tq-arm-bsp-0106)

      * Qualified pin setup

      * USB Overcurrent Protection enabled

      * Login as non-root user allowed

      * add support for MMC SETDSR command

      * add proprietary device tree option to setup e-MMC DSR

      * remove hard-code enet_clk output enable

 

    * U-Boot 2013.04 (new) (2013.04-tq-arm-bsp-0106)

      * Qualified pin setup

      * Boot from 5V only

      * Support e-MMC > 2GB

      * Remove 120s pause when kernel has no network cable connected

      * Command to burn MAC-Address into OCOTP fuses (otp_mxs)

      * reorder gpio setup order

      * fixed overflow issue on MAC incrementation for ETH1

      * add support for MMC SETDSR command

      * qualified setting of e-MMC drive strength register

      * propagate setting of e-MMC DSR to kernel via device tree modification

      * made enet_clk output driver selectable

      * propagate enet_clk driver selection to kernel via device tree modification

 

- TQMa28-fsl

    * Linux version 2.6.35 (2.6.35.14-tq-arm-bsp-0106)

      * reorder gpio setup order

      * Qualified pin setup

      * remove hard-code enet_clk output enable

      * check for command line option to enable internal enet_clk driver

      * check for command line option to set e-MMC drive strength register

 

    * U-Boot 2009.08 (2009.08-tq-arm-bsp-0106)

      * fix udelay duration

      * reorder gpio setup order

      * Qualified pin setup

      * enable reading FEC MAC address from fuses

      * add support for MMC SETDSR command

      * qualified setting of e-MMC drive strength register

      * propagate setting of e-MMC DSR to kernel via command line modification

      * made enet_clk output driver selectable

      * propagate enet_clk driver selection to kernel via command line modification

 

 

Links:

> Produktseite ARM9 Modul TQMa28 (Downloads)

> Support-Wiki ARM9 Modul TQMa28 (Linux BSP Dokumentation)